NOx Sensor 4G0907807K
201347

NOx Sensor 4G0907807K

BG NOx sensor for VWA6 C7 / 4G,OE 4G0907807K,12V urea/SCR system.

BG Part Number
201347
Category
NOx Sensors
Application
A6 C7 / 4G
Voltage
12V
Vehicle Manufacturer
VW
OE Cross References
  • 4G0907807K

Product Description

This BG NOx (nitrogen oxide) sensor is designed for the urea/AdBlue-based SCR (Selective Catalytic Reduction) emissions system on VW A6 C7 / 4G. It is a direct-fit replacement for OE reference 4G0907807K. Rated for 12V electrical systems. The sensor provides accurate real-time NOx measurement for precise urea dosing control, helping maintain stable SCR performance and compliance with diesel emission standards.

Vehicle manufacturer names, logos and OE reference numbers are used for identification and compatibility purposes only. BEST GROWTH products are independent aftermarket products and are not manufactured, sponsored or endorsed by the respective vehicle manufacturers.

BG 201347 (OE 4G0907807K): function on the vehicle

NOx Sensor 4G0907807K is supplied by BEST GROWTH under part number 201347, cross-referenced to OE 4G0907807K, as a direct-fit aftermarket nox sensors. In service it runs a heated zirconia measuring cell inside its own sensor control module, converts the raw cell current into a NOx value in ppm, and publishes it on the bus. The engine controller cannot calculate dosing quantity or conversion efficiency without a plausible signal from it.

BG 201347 is built to the position defined by its OE application on a 12V electrical system on the platform from Volkswagen. Position, calibration and connector layout are part of the specification, so a part that physically fits is not automatically the correct part.

Fitting position matters as much as the part number: upstream and downstream references often share a housing but carry different calibration data and cable lengths.

Fitment for Volkswagen and OE cross reference

BG 201347 replaces 1 OE reference: 4G0907807K. Always confirm the number printed on the removed part, including any supersession issued by the vehicle manufacturer.

Recorded vehicle coverage for 201347 includes Volkswagen, typically on A6 C7 / 4G. Coverage lists are a starting point for identification, not a substitute for checking the OE number on the vehicle.

Quote the number printed on your part with the engine code when you enquire; a single-reference part is the most common source of ordering errors when a platform received a mid-life update.

Symptoms that lead to replacing 4G0907807K

These complaints bring a vehicle in with the Volkswagen nox sensors under suspicion. None of them prove BG 201347 has failed on its own, which is why the checks below matter before a replacement is ordered.

  • SCR efficiency below threshold or NOx-signal-implausible fault codes
  • DEF over-consumption with no visible leak
  • torque derate or speed inducement with a full, in-spec DEF tank
  • no communication with the sensor control module after a cold start
  • sensor value frozen at a fixed number once the exhaust warms up

Checks before fitting BG 201347

Aftertreatment faults are usually system faults. Working through these checks prevents a repeat failure after the new nox sensors is fitted.

  • Check for exhaust leaks ahead of the sensor boss; a diluted sample reads low NOx.
  • Read the sensor's own dew-point release time — a cell that never heats is a supply or module fault.
  • Verify DEF concentration with a refractometer before blaming the measuring cell.
  • Check for a pending software or parameter update for the sensor control module on that platform.
  • After fitting, run the manufacturer's adaptation or relearn so stored efficiency counters reset.

Quality, packaging and ordering 201347

BG 201347 is manufactured and tested to aftermarket replacement standards, with electrical, leakage and functional testing carried out before packing on the 12V specification. Bulk and retail packaging, private-label cartons and customer-specific labelling are available for distributors and workshop groups.

Send OE 4G0907807K or the number printed on your part, the engine code and the vehicle identification number with your enquiry, and our technical team will confirm the correct reference, current stock position and lead time before you commit to an order.

Frequently asked questions

Does BG 201347 replace OE 4G0907807K?
Yes. BG 201347 is listed against 4G0907807K. Confirm the number printed on the removed part and any manufacturer supersession before ordering.
Which vehicles does BG 201347 fit?
Recorded coverage includes Volkswagen. It is supplied as a direct-fit aftermarket nox sensors on 12V systems. Adaptation, reset or relearn procedures required by the vehicle manufacturer still apply after installation.
Does this fault code always mean the nox sensors has failed?
No. Exhaust leaks, wiring and connector damage, reductant quality, dosing performance and upstream engine faults can all produce the same codes. Validate those inputs before replacing BG 201347.

Related References

WhatsApp